Category / Section
How to configure the TVS BS-i203s BT Lite 2D Scanner
Published:
1 min read
Updated:
Installation
Step-by-step instructions on how to set up and install the scanner for first-time use.
- Factory Reset: Scan the QR code to Reset the settings.
- Bluetooth Pairing:
- Scanner Pairing with Cradle: Scan the below pairing Code 1 and Code 2 in sequence. The scanner indicator becomes Blue and Flashing
Code 1
Code 2
- Connection with Host Device: Connect the cradle to the Host device and wait till the LED indicator on both scanner and the Cradle becomes Blue. The scanner is now ready to use.
Wireless Inventory mode
- Scan the following QR code to enable the Wireless Inventory mode.
The data will be stored in the in-built memory and transferred to host device.
- Scan the following QR code to enable “Upload all the data and clear the memory” mode.
Delay in Transmit Speed
- Enable 5ms delay in the transmit speed to avoid any data loss during the transfer. Scan the following QR to enable the same.